Table of Contents
Advertisement
Installation
Preparing your site
Note: This device will only work with the ST12MHDLAN4K HDMI® Extender kit. Please
review site preparation steps from the ST12MHDLAN4K manual prior to installing
additional receivers. The ST12MHDLAN4K HDMI extender kit lets you extend your 4K30
video over a Gigabit LAN network, beyond the typical cable length restriction of 330 ft.
(100m) of Gigabit network portals.
Refer to the manufacturer of the network equipment to determine the length
restriction and to ensure the transmitter unit and receiver unit(s) are all within the
restricted range of the nearest network portal.
Note: Ensure the transmitter unit, and receiver unit(s) are all situated near AC electrical
outlets.
1.
Determine where the local video source (i.e. computer, Blu-ray player) will be
located and set up the transmitter device near that location.
2.
Determine where the remote display will be located and set up the receiver near
that location.
3.
(Optional) If using additional displays determine where they will be located and
set the additional receiver unit(s) near that location.
Hardware installation
Video wall or point to multi-point installation with a Gigabit LAN network
1.
Install the transmitter unit
a) Connect a video source device, such as a computer or Blu-ray player, to the
transmitter's video input port.
b) Connect the transmitter's DC 9-12V power jack to an AC electrical outlet, using one
of the included power adapters.
c) (Optional) If you intend to add a separate 3.5 mm audio source that can be
embedded into the HDMI signal and selected as the audio source, connect a 3.5
mm audio cable to your audio source device and to the transmitter's analog audio
source port.
2.
Install the receiver unit(s)
a) Connect a display to the receiver unit's video output port using an HDMI cable.
b) Connect the receiver unit's power jack to an AC electrical outlet, using one of the
included power adapters.
Instruction manual
3
Advertisement
Table of Contents
