Related Manuals for StarTech.com ST128UTPR
Summary of Contents for StarTech.com ST128UTPR
- Page 1 VGA EXTENDER & SPLITTER Ethernet VGA Remote Signal Receiver for Distances up to 360 ft. (100m) ST128UTPR (Requires ST128UTP) Instruction Guide The Professionals’ Source For Hard-to-Find Computer Parts...
- Page 2 FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
-
Page 3: Table Of Contents
Table of Contents Introduction ............2 Connecting Your VGA Remote Receiver . -
Page 4: Introduction
Category 5 patch cables, one for the Remote Receiver and one for the VGA Extender (if using premises cabling) Do you need additional cables? Visit www.startech.com to find what you need and the name of your local StarTech.com dealer. -
Page 5: Connecting Your Vga Remote Receiver
Connecting Your VGA Remote Receiver The VGA Extender and Splitter solution is composed of two different units: a ST128UTP Extender and Splitter (available seperately), along with the ST128UTPR Remote Receiver. The VGA Extender takes the output from a VGA source (usually a computer) and transmits it to one or more Remote Receivers over Category 5 Ethernet cable. -
Page 6: Troubleshooting
The following section provides troubleshooting help. The solutions are arranged in the order they should be attempted in most situations. If you continue to have difficulties after attempting the solutions in this section, please contact StarTech.com technical support using any of the methods on page 7. -
Page 7: Specifications
Receiver, switch it off and/or disconnect it. Symptom: The remote display does not display an image when the local computer connected to the VGA Extender wakes up from Standby Mode. Remedy: Power the remote display OFF and ON again. Symptom: The image on the remote display is distorted, noisy, or displays a “signal error”... -
Page 8: Technical Support
Limitation of Liability In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product. - Page 9 Revised: May 18, 2004...