Golden Compass HD GP620CC Owner's Manual page 19

Compass HD Owner's Manual – Models: GP620 SS, GP620 CC
EXTENDING THE FOOTREST
Refer to the pictures below.
1. Insert a 5mm Allen wrench from the top side into the (2) adjustment screws.
2. Place a 10mm wrench on the backside onto the (2) nuts and loosen the (2) footrest
adjustment screws.
3. Slide the footrest plate to the desired position and tighten the adjustment screws.
NOTE: The maximum extended length is not at the end of the slots.
Top View
ARMREST ANGLE ADJUSTMENT
Refer to the picture below.
1. Lift armrest up.
2. Turn jam nut counter-clockwise to loosen.
3. Turn the adjustment bolt using a 6mm Allen wrench to raise or lower the armrest-
angle. Turning the bolt counter-clockwise will raise the angle. Turning the bolt
clockwise will lower the angle. Turn until desired angle is reached.
4. Re-tighten jam nut by turning clockwise.
5. Repeat steps 1-4 on the other armrest.
COMFORT SETTINGS
Jam Nut
Footrest
Adjustment
Nuts (10mm)
Footrest
Adjustment
Screws (5mm)
20
Revised 10/27/14
Bottom View
Adjustment Bolt
(6mm Allen)