Black & Decker CM2060C Instruction Manual page 10

B
12
16
C
17
SELECTING BATTERY PACK
WARNING:
SAFETY KEY IS REMOVED TO PREVENT
ACTUATION BEFORE SELECTING
ACTIVE BATTERY.
Th e mower is equipped with a
POWERSWAP button (11). Press the
TM
battery selection button (figure D) on the
left or right.
• The side marked "1" activates the left
side battery port.
• The side marked "2" activates the right
side battery port.
NOTE: The mower can be operated with
a single battery pack if the switch is in the
proper position.
D
11
This manual downloaded from http://www.manualowl.com
15
16
MAKE CERTAIN THE
ACTIVE BATTERY, STATE
OF CHARGE INDICATORS
NOTE: State of charge is only indicated
when a battery pack is inserted, or when
the mower is turned on, or when a single
battery is present and the switch is
toggled to connect it to run the mower.
This mower is equipped with a state of
charge indicator located on the base of
the dashboard (10). This is used to display
the active battery port and the current
level of charge in the active battery. When
a battery pack is installed into the battery
ports, the three charge level LEDs will
illuminate for 30 seconds displaying the
current level of charge in the battery and
then turn off. While the mower is in use the
current level of charge for the selected,
active battery will be displayed.
• When the mower is first activated,
all of the LED indicator lights on
the dashboard (10) will temporarily
illuminate.
• The dashboard LED lights on the
inactive battery side will turn off.
• The dashboard LEDs on the active
battery side LED (17) will remain lit and
the three charge level indicator LEDs
(18) will indicate the percent of charge
in the battery. (See chart in figure A.)
• If no LEDs illuminate for the active
battery, toggle the POWERSWAP
button (11) to the inactive battery. If
neither battery LEDs illuminate, charge
the battery.
NOTE: The safety key has to be inserted
for all of the LEDs and switch functions to
occur as described.
E
11
17
10
TM
17
18