Blade Sharpening - Black & Decker CM2060C Instruction Manual

REMOVING AND INSTALLING
BLADE
DANGER:
RISK OF INJURY.
WHEN REASSEMBLING THE BLADE
SYSTEM, ENSURE EACH PART IS
REINSTALLED CORRECTLY, AS
DESCRIBED BELOW. IMPROPER
ASSEMBLY OF THE BLADE OR OTHER
PARTS OF THE BLADE SYSTEM MAY
CAUSE SERIOUS INJURY.
WARNING:
1.
HANDLE TO TURN MOWER OFF,
WAIT FOR THE BLADE TO STOP, AND
REMOVE SAFETY KEY AND BATTERY
PACKS.
2. Cut a piece of 2x4 wood (34) (about
2 feet long) (610 mm) to keep blade
from turning while removing bolt (35).
WARNING:
3.
proper eye protection. Turn the mower
on its side. Be careful of sharp edges
of blade. Position wood and unscrew
bolt counterclockwise with a 1/2"
(13mm) wrench (36) as shown in
Figure V.
4. Remove bolt (35) and washer (37). Pull
off blade (38) as shown in Figure W.
The fan (39) should not be removed.
Examine all pieces for damage and
replace if necessary.
5. The blade can only be attached to the
fan in one direction. To reassemble,
line up the D-shaped hole of the blade
with the D-shaped post of the fan,
ensuring the writing on the blade faces
out away from the mower.
6. To tighten, position the piece of wood
as shown in Figure X to keep the
blade from turning. Slide the bolt
through the washer and tighten the
bolt clockwise into place with a 1/2"
(13mm) wrench (36) as shown in
Figure X.
This manual downloaded from http://www.manualowl.com
RELEASE BAIL
Wear gloves and
V
34
W
37
35
X
35

BLADE SHARPENING

KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES
NOT CUT GRASS CLEANLY.
WARNING:
PROTECTION WHILE REMOVING,
SHARPENING, AND INSTALLING BLADE.
ENSURE THAT SAFETY KEY AND
BATTERY PACK IS REMOVED.
Sharpening the blade twice during a
mowing season is usually sufficient under
normal circumstances. Sand causes the
blade to dull quickly. If your lawn has
sandy soil, more frequent sharpening may
be required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
16
35
36
39
38
36
34
USE PROPER EYE