Table of Contents
Advertisement
Another example;
Volume level can be changed by using "VOLUME"
command. After sending this command, you can verify
the changes from the Display.
The last example ;
When "GETSOURCE" command is entered, current
source should be displayed on the putty window as
shown in the picture below.
Connecting to the Display (RS232 port)
Run the software and select Serial as Connection
Type. Enter the Display's serial port in the field
Serial Line (in the following example it is COM4)
and "115200" in the field Speed. Then click the
Open button.
English - 24 -
Advertisement
Table of Contents
