Summary of Contents for Dogtra TOM DAVIS EDITION 280C
Page 1
TOM DAVIS EDITION 280C FEATURING BOOST 'N BUNGEE Owner's Manual Please read this manual thoroughly before operating the TOM DAVIS EDITION 280C training e-collar. SCAN HERE FOR TUTORIAL...
Page 2
Consult your physician or Dogtra product or other property. medical device maker before using your medical device with a Dogtra product. If you think that your Dogtra PRODUCT SAFETY product is interfering with your pacemaker, defibrillator, Training Methods or other medical device, stop using the Dogtra product.
Optional Accessories HANDHELD TRANSMITTER LCD ......Auto Charger The auto charger for the TOM DAVIS EDITION 280C has an ATTACHING THE BELT CLIP ......... input of 12-volts to 24-volts and has an output of 5-volts USING THE TEST LIGHT ........
Pager Button Nick • Medium output receiver Boosted Belt Clip Constant • Compact receiver with enhanced contact points • Checkered grip on handheld transmitter On/Off Battery Screen Magnetic Charging Red Dot Receptacle & Rubber Plug TOM DAVIS EDITION 280C Transmitter...
To turn off the unit, repeat the same procedure holding the two red dots together momentarily. The LED light will turn red for a brief moment indicating that the receiver has now shut off. Battery Charging Receptacle & Rubber Plug TOM DAVIS EDITION 280C Receiver...
Nick & Continuous Nick The TOM DAVIS EDITION 280C includes an updated The transmitter for the TOM DAVIS EDITION 280C has four Nick button, which now has “Continuous Nick” to add buttons (one on the face of the transmitter, two on the left versatility to your training.
Page 7
Boosted Constant Setting up Boost feature Constant is an uninterrupted stimulation type. By setting 1. Set the stimulation level the desired Boost amount, you can immediately apply the to zero. Boosted Constant stimulation up to 12 seconds. To use the Rheostat Dial Constant at your current displayed level, you will have to...
3. BUNGEE COLLAR Assembly 1. To replace the strap, 4. Bring the strap over the prepare a new BUNGEE flat side of the D-ring. Inside COLLAR strap and the Insert the screw clasp with screw clasp. the grooved screw clasp inside and the flat side on Screw BUNGEE...
If the receiver is Cordloc wheel up to lock too loose, the contact will not be consistent and cause the the Cordloc. corrections to be inconsistent. Dogtra uses medical grade stainless steel contact points and anti-microbial plastic to protect the dog’s skin. Caution Do not pull and lock the Cordloc too tightly as it may be uncomfortable for your dog.
5. Finding the Right Stimulation The TOM DAVIS EDITION 280C has a Rheostat Dial on the top of the transmitter (0 is the lowest and 127 is the highest). Remember that you will need to adjust the...
NOTE 2: The unit has a partial charge when it leaves the amber, or red based on the remaining battery life), as Dogtra facility. Upon receipt of the system, be sure to give long as you hold the button down, for up to 12 seconds.
Follow the steps below to charge your system: 9. Handheld Transmitter LCD 1. Open the rubber plugs on the battery charging receptacles and plug in the charging cable. 2. Plug the charger into a 120-volt wall outlet or, if using the auto charger, plug into a cigarette lighter only for lithium polymer batteries (use a 220 volt European charger for Europe).
10. Attaching the Belt Clip in agreement with the dial. In this situation, it is ideal to either wait until your transmitter is back in working order before emitting a correction or slowly turn the Rheostat Dial while holding down the Constant button to see your dog's reaction.
11. Using the Test Light receiver will automatically stop the stimulation if the Constant button is pressed for 12 seconds or longer. 6. Turn the Rheostat Dial on the transmitter clockwise and then counterclockwise. The test light should glow brighter with higher levels of stimulation and dimmer with lower levels.
"teach" the dog the basic For more training information, please visit our website at obedience commands (here, heel, sit, and stay). A tug www.dogtra.com. on the leash/collar is used to reinforce the command. When the dog complies with the command, use positive reinforcement/praise.
2. The LED indicator light comes on, but I do not feel any If the unit is malfunctioning, please refer to the stimulation. “Troubleshooting Guide” before sending it to Dogtra for – Testing the system at various levels using the test light service. If you have any questions or concerns, you may is the best way to test your system.
Page 17
No dealer of Dogtra products, nor any employee or agent of Dogtra, is (888) 811-9111. authorized to make any additions, changes, or extensions to the Warranty. Dogtra, at its sole discretion and at any time, reserves the right to modify the Warranty.
Page 18
Dogtra’s liability is limited to the cost of repair or replacement of the Dogtra fees, for products sent to Canada. Such costs, taxes, or fees will be borne by product under Warranty.