Dryer Description; The Features; Control Panel - Hotpoint AQUALTIS AQC9 CF7 Instruction Booklet

Dryer Description

To open door
Pull on handle
Condenser unit
(cover open)

Control Panel

On/Off Button & Light
Programme Knob
The On/Off button/ light
button is pressed and held for more than 3 seconds the dryer
is turned off. The light signals that your dryer is in use or ready
to select a programme.
The Programmes knob sets the programme: rotate until the
indicator is pointing to the programme you want to select (see
Start and Programmes).
The Option buttons/ lights select available options for your
selected programme. The lights indicate that the option has
been selected (see Start and Programmes).
The Display Panel has three sections: Sensor Dry = Drying
level, Timed dry = Drying time and Time to End / Delay start
each with a corresponding selection button (see The Display).
START/PAUSE button with indicator light
green indicator light flashes slowly, press the button to
start the programme. When the cycle has started, the
indicator light is illuminated in a fixed manner. To pause the
programme, press the button again; the indicator light will
turn orange and begin to flash again.
To restart the programme from the point at which it
was interrupted, press the button again (see Start and
Programmes).
Note: this light also flashes amber during post care phase.
Option Buttons and Lights
Display Panel
Sensor Dry
Timed Dry
, if the dryer is running and this
: when the

The Features

Rating
Plate
Water
container
Filter
Start/Pause
ECO
Button & Light
Light
Delay
Clean
Timer
Condenser
Light
The Programme Progress Lights indicate each state of
the programme by turning on as appropriate (see Start and
Programmes).
"h2o"
The Empty Water indicator
container should be emptied. The light will take a few seconds
to go out after replacing the empty water container; the dryer
must be running for this to happen (see The Controls).
Note: if the water bottle is full the display shows
indicator flashes, the heat is turned off and your clothes will
not dry.
The Empty Water / Clean Filter Light
before every programme, that its essential to clean the filter and
empty the water container every time the dryer is used (see
Maintenance and Care).
The Clean Condenser Light
essential to clean the condenser at regular intervals (see
Maintenance and Care).
The Child Lock button/light
selecting your programme and any options. This prevents the
programme settings from being changed.
When the light is lit the other buttons and programme knob are
disabled. Hold the button to cancel and the light will go out.
ECO Light - this light is illuminated as you select options that
use less energy (see the controls).
Model
& Serial
Numbers
Air Intake
Condenser
cover handle
(Pull to open)
Programme
Progress Light
Child Lock
Empty
Button & Light
Water /
Clean Filter
Light
signals that the water
"h2o"
and the
gives a reminder
gives a reminder, that its
Press and hold this button after
GB
Grille
41