Table of Contents
Advertisement
FOR MODELS BAR72G, BAR72GLH, ADA72G and ADA72GLH:
DANGER – RISK OF FIRE OR EXPLOSION. FLAMMABLE RFRIGERANT
USED. TO BE REPAIRED BY TRAINED SERVICE PERSONNEL. DO
NOT PUCTURE REFRIGERANT TUBING,
These appliances are CFC- and HFC-free and contain a small quantity of Isobutane (R600a)
which is environmentally friendly, but flammable. It does not damage the ozone layer, nor
does it increase the greenhouse effect. Care must be taken during transportation and setting
up of the appliance that no parts of the cooling system are damaged. Leaking coolant can
ignite and may damage the eyes.
In the event of any damage:
- Avoid open flames and anything that creates a spark,
- Disconnect from the electrical power line,
- Air the room in which the appliance is located for several minutes and
- Contact the Service Department for advice.
The more coolant there is in an appliance, the larger the room it should be installed in. In the
event of a leakage, if the appliance is in a small room, there is the danger of combustible
gases building up. For every ounce of coolant at least 325 cubic feet of room space is
required. The amount of coolant in the appliance is stated on the rating label. It is hazardous
for anyone other than an Authorized Service Person to carry out servicing or repairs to this
appliance.
Take serious care when handling, moving, and using the appliance to avoid either damaging
the refrigerant tubing or increasing the risk of a leak.
Replacing component parts and servicing shall be done by factory authorized service
personnel so as to minimize the risk of possible ignition due to incorrect parts or improper
service.
Use two or more people to move and install the refrigerator. Failure to do so can result in back
or other injury.
To ensure proper ventilation for your appliance, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 60
°
°
90
F (32
C). This unit must be installed in an area protected from the elements, such as wind,
rain, water spray or drips.
The appliance should not be located next to ovens, radiators or other sources of high heat.
The appliance must be installed with all electrical connections in accordance with state and
local codes. A standard electrical supply (115V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances, is required.
Do not kink or pinch the power supply cord of the appliance.
The fuse (or circuit breaker) size should be 15 amperes.
It is important for the refrigerator to be leveled in order to work properly. You may need to
make several adjustments to level it.
Never allow children to operate, play with or crawl inside the refrigerator.
Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
damage or discolor the interior.
Do not use this apparatus for other than its intended purpose.
THESE MODELS ARE DESIGNED FOR COMMERCIAL USE.
2
°
°
F (16
C) and below
Advertisement
Table of Contents
