Salt Indicator ( ); Rinse Aid Indicator ( ); End Of Programme; Water Cut-Off Warning - Beko DFS28R20W User Manual

Operating the product
2. Release the key when the Start / Pause
indicator starts flashing. For a couple
of minutes the machine will fulfill
the necessary operations required to
cancel the programme.
C
There might be residues of
detergent or rinse aid left in the
machine and / or on the pieces
being washed depending on the
step the programme you have
cancelled was in.

Salt indicator ( )

Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt warning indicator
appears on the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.

Rinse Aid indicator ( )

Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid warning
indicator appears on the display of your
machine.

End of programme

End of Programme indicator will light up
once the washing programme is over.
1. Press the On/Off button to turn off
your machine.
2. Close the tap.
3. Unplug the machine from the socket.
Dishwasher / User's Manual
C
For energy saving, the product
is automatically turned off
following the completion of the
programme or if the programme
is not started.
C
Leave your dishes in the
machine for about 15 minutes
to cool down after they are
washed. Your dishes will dry
in a shorter time if you leave
the door of your machine
ajar during this period. This
process will increase the drying
effectiveness of your machine.

Water cut-off warning

If mains water is cut or water inlet tap
is turned off the machine cannot take
water in and E:02 icon will flash on the
programme indicator. As long as the
problem continues, washing programme
is paused and the water inlet is checked
regularly by the machine; when the water
is restored E:02 icon will disappear after
a while and the washing programme
resumes.

Overflowing warning

If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and E:01
icon will flash on the Programme indicator.
As long as the overflowing continues
safety algorithm will be active and try
to discharge the water. If overflowing
stops and safety is assured, E:01 icon
will disappear. If E:01 does not disappear,
there is a permanent fault. In this case the
authorised service should be contacted.
29 / 39 EN