Table of Contents
Advertisement
Preparation
Test Strip
a
b
Remove the
Let the water
test strip from
flow from your
its packing.
tap for 1 minute.
To Adjust the Water Hardness
1. After turning on the machine, press Time Delay and P+/P keys simultaneously. After the
countdown (3,2,1) is displayed keep the keys pressed for a while.
2. Press P+/P key to activate the position.
3. Using Time Delay key, adjust water hardness level according to the hardness of the
supply water. See "Water hardness level adjustment table" for correct setting.
4. Press On / Off key to save the setting.
Water Hardness Level Adjustment Table
English
German
Hardness
Water
Water
Level
Hardness
Hardness
°dE
1
Level
st
0-5
2
Level
nd
6-9
3
Level
rd
10-15
4
Level
th
16-19
13-15
5
Level
th
20-24
16-19
6
Level
th
25-62
20-50
If the hardness level of the water that you use is above 90°dF (French standard for water
hardness) or if you are using well water, than it is recommended to use filter and water
purification devices.
*
If the hardness level of the water that you use is below 8°dF (French standard for
water hardness), there is no need to use salt in your dishwasher. If this is the case, Salt
Indicator (if any) illuminates continuously on the panel of your machine.
If the water hardness is set to level 1, the Salt Indicator will illuminate continuously
although it is not necessary to use salt. If you use salt under this condition, salt will not
be consumed and the lamp will not illuminate.
/39 EN
14
c
d
1 second
Take the test strip
Fill a glass with
out of the water and
tap water and
dip the test strip
shake it.
into water for 1
second.
Position of
French
Regeneration
Water
Adjustment
Hardness
Switch**
°dH
°dF*
0-4
0-8
5-7
9-13
8-12
14-22
23-27
28-34
35-90
e
f
Level 1
Level 2
Level 3
Level 4
1 minute
Level 5
Level 6
Hold for
Set the water hardness level of your dishwasher
1 minute.
according to the result shown by the test strip.
Water Hardness Level Indicator
Press the Time Delay key to switch the
water hardness level to position 1.
Press the Time Delay key to switch the
water hardness level to position 2.
Press the Time Delay key to switch the
water hardness level to position 3.
Press the Time Delay key to switch the
water hardness level to position 4.
Press the Time Delay key to switch the
water hardness level to position 5.
No Lime
Very low lime content
Low lime content
Medium lime content
High lime content
Very High lime content
** Regeneration Adjustment
Switch
Perform the same hardness
level adjustment that you
have set on the control panel
also with the regeneration
adjustment switch. For
example, if you have adjusted
to "3" in the control panel,
also set the regeneration
adjustment switch to 3.
Dishwasher / User's Manual
Advertisement
Table of Contents
