Table of Contents
Advertisement
Keep the appliance area clear
and free from combustible ma-
terials, gasoline and other flam-
mable vapors and liquids.
Solid fuels shall not be burned in
a fireplace in which an unvented
room heater installed.
Children and adults should be
alerted to the hazard of high tem-
perature and should stay away to
avoid burns or clothing ignition.
1. This appliance, as supplied, is only for use
with the type of gas indicated on the rating
plate. This appliance is not convertible for
use with other gases.
2. Do not place propane/LP supply tank(s) in-
side the structure. Locate propane/LP supply
tank(s) outdoors (propane/LP units only).
3. If you smell gas
• shut off gas supply
• do not try to light any appliance
• do not touch any electrical switch; do not
use any phone in your building
• immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions
• if you cannot reach your gas supplier,
call the fire department
4. This heater shall not be installed in a bed-
room or bathroom, unless installed as a
vented appliance. See Installing Damper
Clamp Accessory for Vented Operation,
page 12. This gas log set may not be
installed as a vented appliance in a bed-
room or bathroom in the Commonwealth
of Massachusetts.
5. Before installing in a solid fuel burning fire-
place, the chimney flue and firebox must
be cleaned of soot, creosote, ashes and
loose paint by a qualified chimney cleaner.
Creosote will ignite if highly heated. Inspect
chimney flue for damage. If damaged,
repair flue before operating appliance.
6. If fireplace has glass doors, never operate
with glass doors closed, If you operate
heater with doors closed, heat buildup
inside fireplace will cause glass to burst.
Also if fireplace opening has vents at the
bottom, you must open the vents before
operating heater.
4
SAFETy
Continued
7. To prevent the creation of soot, follow the
8. Before using furniture polish, wax, carpet
9. This heater needs fresh, outside air ventilation
10. Do not run heater
11. Do not use heater to cook food or burn
12. Do not use heater if any part has been ex-
13. Do not operate heater if any log is broken.
14. Turn heater off and let cool before servic-
15. Make sure the selector switch is in the
16. Remote-ready heaters shall not be con-
17. Operating heater above elevations of
18. To prevent performance problems, do
19. Provide adequate clearances around air
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
www.desatech.com
instructions in Cleaning and Maintenance,
page 21.
cleaner or similar products, turn heater off. If
heated, the vapors from these products may
create a white powder residue within the burn-
er box or on adjacent walls and furniture.
to run properly this heater has an Oxygen De-
pletion Sensing (ODS) safety shutoff system.
The ODS shuts down the heater if enough
fresh air is not available. See Air Combustion
and Ventilation page 6. If the heater keeps
shutting off, see Troubleshooting, page 22.
• where flammable liquids or vapors are
used or stored
• under dusty conditions
paper or other objects.
posed to or under water. Immediately call
a qualified service technician to inspect
the room heater and to replace any part
of the control system and any gas control
which has been under water.
Do not operate heater if a log is chipped
(dime-size or larger).
ing, installing or repairing. Make sure the
selector switch is in the OFF position. Only
a qualified service person should install,
service or repair heater.
OFF position when you are away from
home for long periods of time.
nected to any external electrical source.
4,500 feet may cause pilot outage.
not use propane/LP tank(s) of less than
100 lb. capacity (propane/LP units only).
openings.
WARNING: Failure to position
116412-01E
Advertisement
Table of Contents
