RIDGID R4850 Operator's Manual page 10

HOW TO PREPARE FOR DUST
MANAGEMENT
You have two options for dust management. The first is the dust
deflector and the second is the dust collection attachment to at-
tach your machine to a dust collector.
Note: The dust deflector comes factory installed and can be
used if the user elects not to use a dust collector system.
How to Install the Dust Collection
Attatchment
Disconnect the machine from the power
source.
1.
Using the cutterhead height adjusting handle, raise the
main housing up high enough to allow clearance for the
T-handle torx wrench.
2.
Using the wrench provided, remove the two M6 x 20mm
Torx screws and flat washers
deflector. Save these for step 4. (See Figures 5 & 6)
3.
Remove the dust deflector
4.
Align the four slots in the dust collection attachment
with holes in the frame (Figure 8). Secure using four M6
x 20mm Torx screws and washers
2).
5.
Reverse the procedure for installing the dust deflector.
Install the dust deflector with the label up and curved lip
pointing down.
6.
Store the two extra mounting screws with the dust
collection attachment.
When using the dust collection attachment,
DO NOT operate the unit without a hose connected and a dust
collector in operation. The dust collection attachment is designed
to accept a 4 inch hose.
ASSEMBLY
that secure the dust
PC6
. See Figure 7.
F11
(two from step
PC6
PC5
10
FIGURE 5
PC6
FIGURE 6
F11
FIGURE 7
PC6
F16
FIGURE 8