Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eurotops 47133
Summary of Contents for Eurotops 47133
-
Page 2: Table Of Contents
Content Preface .................. 1 Attention ................1 Package Content ..............2 Product Specification ............. 3 Function Introduction ............. 4 Getting Start................6 Manual Setting ............... 6 Alarm Function Setting ............8 Activate/Deactivate the Alarm Function ........8 Manual Setting of the Alarm ........... 9 Turn off the Alarm Tone .............. - Page 3 13.3 Barometric Pressure Trend ..........16 14. Low Battery............15. USB Charger............16. Waste Disposal ..............19...
-
Page 4: Preface
.Preface Thanks for choosing this device . Before You Start Using It • Make sure to read the instruction manual carefully. This information will help you to familiarize yourself with your new device, to learn all of its functions, and to get advice in the event of problems. -
Page 5: Package Content
as a result of improper use or repair by a nonfactory approved technician. • Do not place the product in direct sunlight and high temperature places (radiator, electric heater, stove, etc.). • Keep the product away from strong electromagnetic waves, strong static electricity, or moisture and condensation. - Page 6 • Multiple color backlit • Temperature: • Indoor temperature: 0°C ~50°C • Outdoor temperature: -20°C ~60°C • Temperature alternatively in °C or °F • Wireless sonsor Wall mounting or table stand • 50m transmission range in an open area • Weather forecast •...
-
Page 7: Function Introduction
Function Introduction 11 12 Snoozetouchbutton Outdoortemperature Projectiondisplay Monthanddate Weatherforecasting "MODE"button Time ( DCF ) "MEM"button Week "+"button Indoortemperature "-"button... - Page 8 Alarm 1 on/off switch Alarm 2 on/off switch USB Charging port 16. Projection on/off port 17. "LOOP" button 18. "RAINBOW" button 19. Battery compartment 20. DC power interface 21. Wireless remote sensor 22. Wireless remote sensor battery compartment...
-
Page 9: Getting Start
Getting Start Open the battery compartment and insert two new 1.5V AAA batteries into the clock. Ensure that the battery polarities "+" and "-" are correct. Close the battery compartment. When insert the batteries, all the symbols on the LCD display will light up for 3 seconds. - Page 10 Interrupt the reception by pressing the WAVE button again, The DCF symbol disappears. The DCF reception always take place at 1:00 o’ clock in the morning until 5:00 o’ clock. If the reception is not successfully received at 5:00 o’ clock, further attempts will be made again at 1:00 clock in the morning.
-
Page 11: Manual Setting
Manual Setting Long press "MODE" button, the Year display starts to flash. Press "+"/ "-" button to adjust year. Press "MODE" button to confirm the setting. The Month display starts to flash. Press "+"/ "-" button to adjust month. Press "MODE" button to confirm the setting. The Date display starts to flash. - Page 12 The symbol of 12H or 24H starts to flash. Press "+"/ "-" button to to confirm the setting. choose 12H or 24H system. Press "MODE" The Hour display starts to flash. Press "+"/ "-" button to adjust hour. to confirm the setting. Press "MODE"...
-
Page 13: Alarm Function Setting
Alarm Function Setting 8.1 Activate/Deactivate the Alarm Function When the switch of alarm1 or alarm2 is moved to the "ON" position, the symbol of " " " " appears on the LCD display. The alarm function will be activated. When the switch of alarm1 or alarm2 is moved to the "OFF"... -
Page 14: Turn Off The Alarm Tone
Please take note of the following: The clock will automatically switch from setting mode to normal mode if no button is pressed within 20 seconds. 8.3 Turn off the Alarm Tone Alarm tone will automatically turn off after 2 minutes or you can press any button except the "... -
Page 15: Projection Setting
Projection Setting Note: Switch on the projection button for further operation. Temporary Time & Temp Projection When the clock is powered by batteries (not included), by touching " " , the projection will stay on for a few seconds, then the projection will turn out automatically. -
Page 16: Backlit Adjustment
Backlit Adjustment 10.1 Backlight Dimmer When the clock is powered by batteries, touch " " to light up the backlight for a few seconds. When the clock is powered by DC power adapter, the battery will automatically disconnect the power supply, the backlight will always light up. -
Page 17: Wireless Outdoor Temperature Sensor
Wireless Outdoor Temperature Sensor When the clock weather station receives signals from the wireless sensor successfully, outdoor temperature will display on the screen. Press the " +" button to switch different channel to channel1. If the clock weather station fails to receive signal from wireless remote sensor ( "--"... -
Page 18: Maximum/Minimum Temperature Records
12.2 Maximum/Minimum Temperature Records To change the data of indoor/outdoor maximum, minimum temperature, press the button. "MEM" Press button once to show the maximum temperature values. "MEM" Press "MEM" button twice to show the minimum temperature values. Press button three times to return to the current temperature "MEM"... -
Page 19: Weather Forecast
Weather Forecast 13.1 Weather Forecast Statement The clock weather station calculates weather forecast for the next 12 hours based on the barometric pressure trend. The clock weather forecast can't be compared with the professional weather services supported by satellites and high performance computers. - Page 20 Low Battery If the LCD display shows a symbol of " " at "IN" column, please replace the projection clock battery as soon as possible. If the LCD display shows a symbol of " " at "OUT" column, please replace the wireless remote sensor battery as soon as possible. USB Charger When the clock is powered by DC power adapter, the USB socket can be used for charging smart phone and other devices.
- Page 21 • Favor alkaline battery (last longer than saline battery) and when it’s possible use rechargeable battery. • Leave used batteries and accumulators in adapted containers that you can find in some retailers. In that way, metals don’t pollute the environment and the health.
- Page 22 In Croix, 11-2020 CAPTELEC Importé par / Importiert von / Geïmporteerd door / Imported by : CAPTELEC, 59170 Croix - FRANCE...
Need help?
Do you have a question about the 47133 and is the answer not in the manual?
Questions and answers