Antenna - LG Zenith L20V54S Installation And Operating Manual, Warranty

Antenna Hookup
Connect an off-air antenna to the LCD TV/Monitor.
Locate the Antenna/Cable jack on the back
1
of the LCD TV/Monitor.
Connect the antenna wire (Flat or Round)
2
that runs from the wall to this jack,
according to one of the diagrams shown to
the right.
After all connections are complete, plug in
3
the TV. The LCD TV/Monitor is designed to
operate on AC power.
If the antenna is a 75 ohm RF cable, then no
adapters are required.
A 300 to 75 ohm adapter is not included with
the Zenith LCD TV/Monitor.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking
through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
ADAPTER
on one end and a round opening with a wire sticking out on the other end.
RS-232C
SELECT
CONTROL
Connections Panel
Flat Wire
(300 ohm)
RS-232C
SELECT
CONTROL
Connections Panel
RF Coaxial Wire
(75 ohm)
SPEAKER SWITCH
FUTURE
PILLOW NORMAL
USE SPEAKER SPEAKER
NORMAL
(DTV)
300/75 ohm
Adapter
SPEAKER SWITCH
FUTURE
PILLOW NORMAL
USE SPEAKER SPEAKER
NORMAL
(DTV)
P A G E 9