z1 This can be selected when using Surround Back speakers.
z2 For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup
in place of Surround Height speakers.
z3 This can be set when "Assign Mode" in the menu is set to "13.1ch" or "11.1ch". (v p. 226)
z4 Use 2 sets of Height speakers in the appropriate sound modes for Dolby Atmos, DTS:X or Auro-3D playback.
Use the Front Height and Rear Height speakers for Dolby Atmos or DTS:X playback.
Use the Front Height and Surround Height speakers for Auro-3D playback.
z5 This can be set when "Assign Mode" in the menu is set to "13.1ch" or "11.1ch", and "Floor" - "Layout" is set to "5ch" or "5ch & SB". (v p. 229)
z6 This combination cannot be selected when Front Wide speakers are being used.
n Settings
Select the signal to be output from the selected speaker terminal.
Only "Center" and "None" can be set for the CENTER speaker
0
terminal.
The HEIGHT4/FRONT WIDE speaker terminal is not used.
0
Front panel
Display
Playback
Settings
Middle
Front Layout
Layout
Front Height &
Top Middle &
Center Height
Top Surround
Front Height &
Surr. Dolby &
Center Height
Top Surround
Rear panel
Settings
Rear Layout
HEIGHT 1
Rear Height
Front Height
Rear Height
Front Height
o View Terminal Config.
This shows how to connect the speaker terminals and PRE OUT
connectors for your "Amp Assign" setting on the menu screen.