Page 3
DEVICE PARTS DESCRIPTION № position on the NAME DESCRIPTION scheme Compressor Nebulizer compressor unit for to create air pressure. Power Switch Tumbler I/O – switch on/switch off power. Connector of Compressor Fitting compressor for connecting an inhalation tube. Intake Holes for air intake to cool the compressor. Nebulizer holder Holder for the nebulizer.
(bronchi expansion) is reached, and the need for hospitalization is eliminated or the hospital stay is reduced. Little Doctor Internatiоnаl (S) Pte. Ltd. offers you to use inhaler LD-221C, whose distinctive features are the possibility to use a wide range of medicines, low inhalation solution residual volume, and reliable and simple use.
Page 5
● Do not use mineral water in the nebulizer for nebulizing purposes. ● Always dispose of any remaining medication in the medication tank after each use. Use fresh medication each time you use the device. ● Do not leave the device or its parts where it will be exposed to extreme tempera- tures or changes in humidity, such as leaving the device in a vehicle during warm or hot months, or where it will be exposed to direct sunlight.
Page 6
● Do not spill water or other liquids on the compressor .These parts are not waterproof. If liquid spills on these parts, please unplug the power cord and wipe off the liquid with gauze or other soft absorbent material immediately. ●...
WARNING: ● Do not modify this equipment without authorizaiton of the manufacturer ● Do not service or maintenance the device while in use with the patient. CARE AND DISPOSAL ● Regularly clean the device and all accessories. It is recommended that all the accessories should be wiped with a 3% solution of hydrogen peroxide with addition of 0.5% solution of a detergent (for example, a laundry powder).
Page 8
% to the total mass Dispenser "A" (yellow) (mainly lower respiratory tract) For effective delivery medicines to a specific site of respiratory tract, need to use the appropriate dispenser. Fig. 4 particle sizes, mkm * - Measured by Little Doctor International (S) Pte. Ltd.
Performing the inhalation. The length of one treatment session should not exceed 20 minutes. Consult your attending physician about the length of the inhalation procedure. You should always be calm and relaxed during the inhalation. Breathing should be slow and deep, so that the preparation could fi ll the lungs well and reach the deep portions of bronchi.
COMPLETENESS № NAME MODEL QUANTITY, pc. Compressor — Nebulizer (with inhalation baffl e LD-N002) LD-N105 Inhalation baffl e LD-N001 Inhalation baffl e LD-N002 Inhalation baffl e LD-N003 Inhalation mouthpiece LD-N022 Adult inhalation mask LD-N041 Child inhalation mask LD-N040 Inhalation tube LD-N051 10 Adult nasal nozzle LD-N058...
Page 11
126mm x 98mm x 173mm Net Weight, no more 1400 g Protection against electric shock type BF * - Measured by Little Doctor International (S) Pte. Ltd. SYMBOLS CE marking in conformity with EC directive 93/42/EEC Type BF Important: Read the manual...
Kazakhstan. Phone: +7 (7232) 76-97-97. E-mail:info@kаzmedimport.kz. www.kazmedimport.kz Manufactured under control: Little Doctor International (S) Pte. Ltd., 7500A, Beach Road, 11-313 The Plaza 199591, Singapore. Postal address: Yishun Central P.O. Box 9293 Singapore 917699. Manufacturer: Little Doctor Electronic (Nantong) Co., Ltd., No.8, Tongxing Road Economic & Technical Development Area, Nantong 226010, Jiangsu, PEOPLE’S REPUBLIC OF CHINA...
Page 13
Authorized Representative in the EU: Little Doctor Europe Sp. z o.o. 57G Zawila Street Krakow 30-390 Poland.
Need help?
Do you have a question about the LD-221С and is the answer not in the manual?
Questions and answers