Canon PIXMA MP495 Installation Manual page 11

Installing the Drivers & Software
Step Ten
10-A
If the Detected Access Points List screen appears:
If the screen below does not appear, perform 10-B.
1. Select the target access point name/network name (SSID).
2. Enter the network key.
Enter upper and lower case letters of the alphabet correctly.
Letters are case sensitive.
To use WEP key number 2, 3 or 4, click WEP Key Number, then
specify the WEP key number.
3. Click Connect
Go to Step Eleven.
Note:
If the target access point is not displayed on the Detected
Access Points List or Access Points screen, refer to the printed
manual: Network Setup Troubleshooting.
For details on how to check the access point name/network
name (SSID) and network key, refer to the manual supplied
with your access point or contact its manufacturer.
<< Previous Next >>
11