Cleaning - Bush BFSSAE12W Instruction Manual

Care and maintenance
Looking after your appliance

Cleaning

Cleaning your dishwasher is important
to maintain the machine's service life
Make sure that the water softening
setting (If available) is done correctly
and correct amount of detergent
is used to prevent limescale
accumulation. Refill the salt
compartment when the salt sensor
light comes on.
Oil and limescale may build up in your
Dishwasher over time. If this occurs:
• Fill the detergent compartment
but do not load any dishes.
Select a programme which runs
at high temperature and run the
Dishwasher empty. If this does not
clean your Dishwasher sufficiently,
use a cleaning agent designed for
use with dishwashers.
• To extend the life of your
dishwasher, clean the appliance
regularly on each month
• Wipe the door seals regularly
with a damp cloth to remove any
accumulated residue or foreign
objects.
6.1. Filters
Clean the filters and spray arms at least
once a week. If any food waste remains
or foreign objects on the coarse and
fine filters, remove them and clean
them thoroughly with water.
a) Micro Filter b) Coarse Filter
c) Metal Filter
1
3
c
To remove and clean the filter
combination, turn it counter clockwise
and remove it by lifting it upwards (1).
Pull the coarse filter out of the micro
filter (2).Then pull and remove the
metal filter (3).Rinse the filter with
lots of water until it is free of residue.
Reassemble the filters. Replace the
filter insert, and rotate it clockwise (4).
If y ou requir e any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
Care and maintenance
31
2
b
a
4
• Never use your dishwasher without
a filter.
• Incorrect fitting of the filter will
reduce the washing effectiveness.
• Clean filters are necessary for
proper running of the machine.
6.2. Spray arms
Make sure that the spray holes are not
clogged and that no food waste or
foreign object is stuck to the spray
arms. If there is any clogging,remove
the spray arms and clean them under
water. To remove the upper spray arm
undo the nut holding it in position by
turning it clockwise and pulling it
downwards. Make sure that the nut is
properly tightened when refitting the
upper spray arm.
6.3. Drain Pump
Large food residues or foreign objects
which were not captured by the filters
may block the waste water pump. The
rinsing water will then be above the
filter.
Warning Risk of cuts!
When cleaning the waste water pump,
ensure that you do not injure yourself
on pieces of broken glass or pointed
implements.
In this case:
1. First always disconnect the appliance
from the power supply.
2. Take out baskets.
3. Remove the filters.
4. Scoop out water, use a sponge if
required.
5.Check the area and remove any
foreign objects.
6. Install filters.
7. Re-insert baskets.