NAPCO GEM-DK1CA Operating Manual page 16

A C T I V A T E
B E L L T E S T
D I S P L A Y
S Y S T R B L
D I S P L A Y
F I R E A L A R M
D I S P L A Y
F I R E T R B L
A C T I V A T E
C H I M E
A C T I V A T E
W A T C H
16
F U N C T I O N M E N U
Activate Bell Test?
performs a battery test. If the alarm does not sound, call for service.
Y / N
•
If the battery is low, a "LOW BATTERY E02-00 SERVICE" will appear in the display
indicating a low battery condition. Allow 24 hours for the battery to recharge. If the
trouble continues, call for service.
Display System Troubles?
a problem detected in the system. (See SYSTEM TROUBLE ERROR CODES for a full
Y / N
description of these codes). Use NEXT(
troubles.
(For GEM-P9600/3200 panels only).
Display Fire Alarms?
NEXT and PRIOR Buttons to scroll zones (required for GEM-P3200/9600 panels. GEM-
Y / N
P816/1632 panels will auto-scroll).
Display Fire Troubles?
Zone(s). Use NEXT(
Y / N
P3200/9600 panels. GEM-P816/1632 panels will auto-scroll).
Activate Chime?
programmed zone is faulted while disarmed. To deactivate the Chime Mode, re-enter the
Y / N
Function Mode and when "DEACTIVATE CHIME" is displayed, press YES (
The Chime Mode is disabled while armed.
Activate Watch Mode?
optional feature simultaneously turns on all zones designated as Day Zones, which will
Y / N
cause an indication at the keypad if a zone is opened while the system is disarmed. To
deactivate the Watch Mode, arm, then disarm. All Day Zones will revert to regular Burglary
Zones. Note: The Watch Mode is disabled while armed.
GEM-P9600 and GEM-P3200 control panels only).
Activates the alarm (while disarmed) for about 2 seconds and
Displays 1- or 2-digit error code along with a description of
P
Displays alarms that have occurred on the Fire Zone(s). Press the
Displays trouble conditions that have been detected on the Fire
P ) and PRIOR ( Q
The Chime Mode will sound a tone at the keypad when the
(Optional - Watch Mode programmed?
) and PRIOR ( ) to scroll system
Q
) to scroll zones (required for GEM-
P
YES
(Note: This function available with
). Note:
NO) This