Engine Operation; Operating Controls - California Trimmer RL2510 Operator's Manual

Preparation
1. Thoroughly inspect the area where mower is to be
used, and remove all stones, sticks, wire, bones and
other foreign objects which might be picked up and
thrown.
2. Do not operate mower when barefoot or wearing
open sandals. Always wear substantial foot wear, and
pants or slacks that cover your legs when operating
mower.
3. Check fuel before starting engine. Do not fill gasoline
tank indoors, or when engine is running. Wait until
engine has been allowed to cool for several minutes.
Clean off any spilled gasoline before starting engine.
4. Disengage clutch drive before starting engine.
5. Do not use mower unless all guards are properly in
place.
6. Mow only in daylight or in good artificial light.
7. Always be sure of your footing. Keep a firm hold on
the handle and walk, don't run.
8. Inspect the unit to verify the controls, safety switches
and shields are attached and functioning properly. Do
not operate unless they are functioning properly.

Engine Operation

A variety of engines are used on the California Trimmer
Reel Mowers and their specific identification is provided
as the last part of the overall unit's model number.
Example as follows: RL255-GX160 – (GX160 is the
engine model no).
Review the complete operation and safety
instructions provided in the owner's manual of the
respective engine manufacturer – which is included
in the information packet of this unit.
Any service, warranty or replacement parts issues for
the engine should be directed to Authorized Service
Dealers of the respective engine manufacturer.

Operating Controls

Evergreen Turf Equipment, LLC • 1028 4
REEL MOWER OPERATOR'S MANUAL
Make sure all handles are in the upright and
disengaged position before starting engine.
1. Clutch Engagement
This engages both the roller and reel cutting blade
rotation. Push the handle forward until engagement
occurs. Pull the handle back to disengage.
The clutch must be disengaged before starting the
engine.
2. Drive Roller Engagement
The drive roller propels the unit when it is lowered on
to the ground. Once the engine is started and the
clutch is engaged, the drive roller will be rotating.
Keep the engine speed low and begin pushing the
unit forward as the drive roller is lowered to the
ground.
3. Engine Stop Switch
Reduce the engine speed using the throttle
lever, lift the drive roller and disengage the
clutch before stopping the engine. Never stop
the engine while the unit is moving or blades
are rotating.
- Honda models GX120 & GX160
It is located on the front side of the engine.
- Honda models GC160 and GS160
The stop switch is incorporated into the throttle
linkage, so moving the throttle lever completely to
the left will activate the switch and stop the engine.
th St. SW, Bldg. A • Auburn, Washington 98001 • caltrimmer.com