Related Manuals for Velocity VR96
Summary of Contents for Velocity VR96
- Page 1 Assembly Instructions Velocity Desk Return (Universal) 1 CARTON MANUFACTURER CODES: VR96 OW CODES: CPVELRETGR, CPVELR90BW, CPVELRETWH, CPVELR90WI manufactured by designtec www.designtec.com.au 1 / 6...
-
Page 2: Tools Required For Assembly
NOTE Please check you have all hardware before assembling. If you are missing any hardware, please contact the store of purchase. Please ensure you have the name of the item, required hardware part and quantity. Please retain your receipt as proof of purchase to validate your warranty. CAUTION Do not tighten screws before all screws are in the right place. - Page 3 IMPORTANT NOTE: This return is universal so can be used on the Left Hand Side (LHS) or Right Hand Side (RHS) of your Velocity Desk. For a LHS return, see below pages 3-4. For a RHS return, see pages 5-6.
- Page 4 Noting that one half of the joining plate will over hang the top, allowing it to be attached to the underside of your Velocity Desk. NOTE: There will be pre-drilled holes under the top of your Velocity Desk to allow for easy attachment, use the remaining four (4) SCREWS (D) and secure with a screw driver.
- Page 5 STEPS FOR USING AS A RIGHT HAND SIDE RETURN: STEP 1 Insert three (3) PINS (B) into pre-drilled holes on end panel. Then insert two (2) ADJUSTABLE FEET (A) into the pre-inserted threaded sleeve. END PANEL STEP 2 Insert four (4) PINS (B) into pre-drilled holes on your modesty panel. MODESTY PANEL 5 / 6...
- Page 6 Noting that one half of the joining plate will over hang the top, allowing it to be attached to the underside of your Velocity Desk. NOTE: There will be pre-drilled holes under the top of your Velocity Desk to allow for easy attachment, use the remaining four (4) SCREWS (D) and secure with a screw driver.