Klarstein ICEMEISTER 2G Manual page 23

4. Hold and press the ice size selection button
for 3.5 seconds within 5 seconds after plug in. Then three beeps can be heard and
the appliance enters into the cleaning mode. At that time, the indicators for the ice
cube size large , medium
blink in sequence, and the pump will start to pump water and keep running for 15
minutes, and it will enter into standby condition after running for 15 minutes, finally,
open the drain plug and empty the water.
5. Clean the ice cube maker interior with a soft cloth soaked with warm water and
vinegar, then rinse with clean water and then drain all the water.
6. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water. Rinse and dry.
7. Clean the exterior of the ice cube maker with a soft damp cloth. Use a mild
dishwashing soap, if necessary.
Note: Do not use organic solvent, boiled water, detergent, strong acid and strong
alkali etc. for cleaning.
Note: Do not clean the evaporator.
8. Please empty the water reservoir and dry it for storage if the ice cube maker is not
used for a long time.
and the timer setting button
, small and the ice basket full indicator
EN
23