Advertisement
With a shovel, score the ground around the outside edges of the sandbox boards on the
'high' side of the fort. This is the area that will be dug in. Make sure to score deep enough;
the scored lines will be your digging template.
Push the frame off and away from the scored area, far enough to dig and remove dirt to
reach the appropriate depth.
Dig a channel along the scored line(s) for the base of the fort (corner post and sandbox
boards) to rest into. Dig the channels) to the same level depth. The bottom of the
channel(s) should be level to each other, so your frame doesn't teeter or rock because the
channel(s) are uneven.
Once you have removed enough grass and dirt, slide/push the frame into the channel(s).
Place a level on the vertical and horizontal boards of the frame to determine if enough soil
or too much, was removed.
Repeat this process until the basic frame is plumb and level and in its final position before
completing the rest of the assembly. Measure to make sure fort is square.
Important: if you require a channel depth of more than 150mm, then we recommend you
have your play set area professionally graded before completing assembly. **
Assembly Advice
•
Follow the instructions exactly.
•
This product must be assembled by adults.
•
Once assembly has been completed, keep the instructions in a safe place for future
reference. This can be particularly handy for identification of parts if any after sales
service is required.
•
Before commencing assembly, check that none of the parts are missing. If you find that
that you are missing a part, please contact our after-sales service department.
•
Retain extra parts to use as spares in the future if necessary.
•
Pre-Drill timber before fixing with screws to avoid cracks in the timber.
•
The dimensions given in the instructions are indicative only, they may vary according to
the assembly method
11
Advertisement
