Table of Contents
Advertisement
Verifying the Installation
5.2
No.
Acceptance Criterion
1
The battery is installed correctly and securely.
2
The cables are routed properly as required by the customer.
3
Cable ties are secured evenly and no burr exists.
4
The ground cable is connected correctly and securely.
5
The battery switch and all switches connected to the battery are OFF.
6
The DC input power cables and signal cables are connected correctly and securely.
7
Idle terminals and ports are locked by watertight caps.
8
The installation space is proper, and the installation environment is clean and tidy.
6
System Power-On
Product Overview
To prevent the device from being exposed to high humidity in the power-off state, you are
•
advised to power on the LUNA2000 within 24 hours after unpacking it. The period for which the
device remains powered-off during maintenance must not exceed 24 hours. Otherwise,
condensation may cause damage to the device.
•
After turning on the battery switch, power on the inverter. For details about how to power on
the inverter, see the quick guide for the corresponding inverter model.
If no PV module is configured, press the black start button.
•
Turn on the DC switch on the battery. After the battery is installed and powered on for the first
time, the ring LED blinks for three circles. Observe the battery indicator to check the running status.
Type
Status (blinking at long
intervals: On for 1s and then
Off for 1s; Blinking at short
Intervals: On for 0.2s and then
Off for 0.2s)
Running
indication
Steady green
Blinking green
at long
intervals
Off
Blinking red
at short
intervals
N/A
Steady red
N/A
Meaning
N/A
Steady green
Operating mode
Blinking green
at long
Standby mode
intervals
Off
Sleep mode
N/A
Battery power control module environment alarm
Blinking red at
Battery expansion module environment alarm
short intervals
N/A
Battery power control module fault
Steady red
Battery expansion module fault
19
Advertisement
Table of Contents
