Auriol 4-LD5561-1-2 Usage And Safety Instructions page 101

room climate monitor can be hung from a nail or
screw by using the hole for wall mounting (A),
fastened to a magnetic metal surface or set on a
surface using the Stand (E). Before mounting to a
wall, make sure that there are no gas, water or
electricity lines at the drilling location. Pay attention
to the condition of the wall. The manufacturer is not
liable for any damage caused by improper
mounting.
Protect sensitive surfaces before setup, otherwise
scratches may occur.
Make sure that:
 adequate ventilation is always ensured (do not
place the room climate monitor on shelves or
where curtains or furniture cover the sensors (D)
and leave at least 10 cm space on all sides);
 the device isn't placed on a thick carpet or bed
during operation;
 no direct heat sources (i.e. radiators) influence the
device;
 no direct sunlight reaches the device;
 contact with splashing or dripping water must be
avoided (don't place any items filled with liquids,
i.e. vases, onto or next to the device);
- 99 -