Table of Contents
Advertisement
Flush Channel Installation Guide
Product Overview
The Node Flush Channel assembly consists of two mounting angles held together by intermittent mounting brackets,
which interface with the channel face.
9.84
250
OVERALL WIDTH
4.72
120
EXPOSED WIDTH
Flush Channel with Weave Panel
Flush Channel with Weave Panel
The Node Flush Channel is designed to be installed between ceiling panels or plasterboard, in ceilings with recessed
voids.
The following guide should only be used for Node Flush Channel where PARC is not providing the diffuser or plenum.
Please refer to our Node Flush Channel with Diffuser Installation Guide if you are installing with the Node with Diffuser.
It is recommended that the Node Flush Channel length is coordinated with the manufacturer to the required sizes to
match the building design. The Node Flush Channel can be site cut if required.
The Node devices are supplied separately from the channel assemblies.
Note:
All mounting hardware and sub structure is to be supplied and installed alongside the Node Flush Channel.
Lighting and other services must be installed by qualified personnel.
For further information regarding product or installation, please contact info@parc-ceilings.com.
v001 | Flush Channel Installation Guide
3.57
91
CHANNEL HEIGHT
.23
6
RECOMMENDED CLEARANCE
W/ SURROUNDED CEILING
Figure 1
11.81
300
OVERALL WIDTH
.40
10
4.72
120
FACE WIDTH
Flush Channel with Soft Cell Panel
Flush Channel with Soft Cell Panel
4.16
106
CHANNEL HEIGHT
.12
3
RECOMMENDED CLEARANCE
W/ SURROUNDING CEILING
2
Advertisement
Table of Contents
