Table of Contents
Advertisement
22
Figure 23: Safety interlock switch label
DANGER: Do not tamper with the safety interlock system on the doors or panels.
Do not attempt to open or remove panels while the platesetter is exposing
●
media.
Do not attempt to operate the platesetter with any panels open.
●
Do not try to operate the platesetter if the laser interlock system warning
●
message appears in the device control software.
Tampering with the safety interlock system can expose you to laser radiation and/
or moving mechanical parts. Exposure to visible and invisible high-powered laser
radiation can burn skin and can cause permanent degradation or loss of eyesight.
Moving mechanical parts can create a hazardous situation, which, if not avoided,
will result in death or serious injury.
WARNING: After selecting the Unlock operation in Print Console or rotating the
power switch to the off position, wait a few moments before starting to work
inside the platesetter. It can take up to two seconds for the safety interlock system
to completely shut down laser sources and up to five seconds for the system to
shut down mechanical movement. Exposure to visible and invisible high-powered
laser radiation can burn skin and can cause permanent degradation or loss of
eyesight. Moving mechanical parts can create a hazardous situation, which, if not
avoided, can result in death or serious injury.
WARNING: When you open a door or panel, if you suspect that the safety
interlock system did not shut down laser sources and/or mechanical movement,
use an emergency stop button or the power/emergency stop switch to shut down
the platesetter. Secure the power/emergency stop switch in the off position with a
padlock, and do not operate the platesetter again until it has been approved for
operation by an authorized service representative. A defective safety interlock
system can expose you to laser radiation and/or moving mechanical parts.
Exposure to visible and invisible high-powered laser radiation can burn skin and
can cause permanent degradation or loss of eyesight. Moving mechanical parts
can create a hazardous situation, which, if not avoided, can result in death or
serious injury.
The following label identifies the safety interlock override (SIO) key
switch. Only service representatives are authorized to use this switch.
Operators should never be in possession of the key or attempt to
activate this switch.
Chapter 4—Safety features
Advertisement
Table of Contents
