Auto Operation Mode (Heat Pump Type); Fan Operation Mode - LG UB18 Owner's Manual

Auto Operation Mode (Heat Pump Type)

9
The setting temperature
can be changed, when the
set temperature button is
pressed.
Auto Change Over Operation(Pair system):
❏ You can switch the indoor fan speed.
❏ The system will automatically switch from the cooling mode to the heating mode, or from heating to cooling,
when you select Auto Opration mode.
Auto Operation(Multi system or Simultaneous system):
❏ You can switch the indoor fan speed.
❏ If the system is not operating as desired, manually switch to another mode. The system will not automatically
switch from the cooling mode to the heating mode, or from heating to cooling, then you must set the mode and
the desired temperature again.

Fan Operation Mode

This function is used to circulate room air without cooling or heating.
1
Press the On/Off Button.
2
press FAN Operation Button.
3
Each time Fan Speed button is pressed, the fan speed mode is shifted as shown below.
AUTO SWING OPERATION
Timer Operation unit
On Off
Set no. Time 01 03 05 07
Hi Medium
• The temperature can be set
SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
within a range of 18°C~30°C
MED JET Defrost Humidify
LO Filter Out door
by 1°C.
Time ZONE 1 2 3 4
Program set
09 11 13 15 17 19 21 23
To raise the Temperature.
To lower the Temperature.
Low
Operating Instructions
Owner's Manual 13