Value WT26 Series Manual page 9

Note:
- and will be displayed if the measuring cable is short
circuit. In the meantime, the meter will also display the pair of
wires which is short at the secondary display.
To check the phone line (WT26B/C):
1) Unplug all the cables connected to the main body;
2) Select the phone line mode by pressing the "PORT" button until
the
3) Plug the phone line need to be tested to the RJ11 jack at the top
of the main body;
4) The cable length will be automatically display;
5) After measuring, switch off the main body by holding down
the button for about 3 seconds.
Note:
- and will be displayed if the measuring cable is short
circuit. In the meantime, the meter will also display the pair of
wires which is short at the secondary display.
To check the BNC cable (WT26B/C):
1) Unplug all the cables connected to the main body;
2) Press "PORT" button to select the BNC cable measuring mode.
When it is ready for BNC cable measuring, the
3) Plug the testing cable to be measured to the BNC jack at the top
of the main body;
4) The cable length will be automatically display;
5) After measuring, switch off the main body by holding down
the button for about 3 seconds.
Note:
- and will be displayed if the measuring cable is short
circuit. In the meantime, the meter will also display the pair of
wires which is short at the secondary display.
appears;
Page 5
appears;