Value WT26 Series Manual page 12

BNC cable tracing (WT26B/C):
1) Select the BNC cable tracing mode by press the "PORT" button
until appears;
2) Select analogue or digital signal for tracing by pressing
a) When display showing "-1-" or "-3-", the equipment is sending
analogue signal for tracing;
b) When display showing "-2-", the equipment is sending digital
signal for tracing;
3) Hold down the "SCAN" button on the receiver to switch on the
receiver;
4) Select analogue or digital signal for tracing by pressing the "SCAN"
button,
a) Blue indicator will switch on when the receiver is ready for
receiving digital signal with sound indication;
b) Blue indicator flashing when the receiver is ready for receiving
digital signal with vibrating indication; or
c) Red indicator will witch when the receiver is ready for receiving
analogue signal with sound indication;
5) Move the receiver close to each of the unknown cables. When
the receiver is closed to the cable which is plug in the Main Body
at the other side,
a) largest sound will be heard if blue or red indicator on
the receiver is on; or
b) largest vibration will be obtained if blue indicator on
the receiver is flashing.
6) After tracing, switch off the Main Body by holding down
the button for 3 seconds;
7) Also switch off the receiver by holding down the "SCAN" button for
3 seconds.
Page 8
or ;
▲ ▼