Table of Contents
Advertisement
Troubleshooting
Display
Type of fault
Overfilling
Water outlet fault
Water inlet fault
Inlet valve leakage
Turn off the machine with the On/Left-on mode button and then turn it on again to clear the error message from the display.
Problem
The dishes are not clean.
Spots or films on the dishes.
The dishes have a sticky white/blue film.
Possible causes
The spray arms do not rotate.
Old detergent. Detergent is a perishable
product.
Incorrect detergent dosage.
Dishwashing programme too weak.
Dishes loaded incorrectly.
Glasses and cups have toppled over during
the programme.
The filter is not correctly fitted.
The water softener is leaking salt.
Incorrect water softener setting.
Incorrect rinse aid dosage setting.
Salt compartment empty.
3-in-1/ All-in-one detergent is used and the
setting TAB (3-in-1/ All-in-one detergent) is
activated.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired, only
prevented.
Rinse aid dosage setting too high.
Action
Call the service division.
See "Water remains in the dishwasher" in the table
below.
Check that the water tap is on.
Turn off the water tap and call the service division.
Action
Remove the arms and clean them.
Check that the dishes are not blocking the
spray arms.
Avoid large packages.
Dose according to water hardness. Far too
much or far too little detergent results in
poorer dishwashing results.
Select a higher temperature or a more
powerful programme.
Do not cover porcelain with large bowls or
the like. Avoid placing very tall glasses in the
corners of the baskets.
Place dishes to sit steady.
Screw the filter firmly into place. See the
section Care and cleaning.
Check that the salt compartment lid is
properly tightened. Otherwise call the service
division.
See the section Settings.
See the sections Before washing for the first
time and Settings.
Top up with salt. See the section Before
washing for the first time.
Inactivate the setting TAB (3-in-1/ All-in-one
detergent) and top up salt and rinse aid.
Wash crystal at a low temperature and with
a conservative amount of detergent. Contact
the detergent manufacturer.
Reduce the amount. See the sections Before
washing for the first time and Settings. If you
have very soft water, you may want to dilute
the rinse aid 50:50 with water.
15
Advertisement
Table of Contents
