Panasonic TC-21FG10P Service Manual
  1. Manuals
  2. Brands
  3. Panasonic Manuals
  4. TV
  5. TC-21FG10P
  6. Service manual
Panasonic TC-21FG10P Service Manual

Panasonic TC-21FG10P Service Manual

Hide thumbs Also See for TC-21FG10P:
Table of Contents

Advertisement

Quick Links

Specifications
Power Source :
Power Consumption :
Aerial Impedance :
Receiving Channels :
VHF
CATV
UHF
Intermediate Frequency :
Video
Sound
Colour
All manuals and user guides at all-guides.com
AC AUTO 110-240V, 50/60 Hz
83W
75Ω unbalanced
Coaxial type
2-13 (USA STANDARD)
1-125 (USA STANDARD)
14-69 (USA STANDARD)
38.0 MHz
31.5 MHz (D, K, K1)
32 MHz (I)
32.5 MHz (B, G)
33.5 MHz (M)
33.57 MHz (PAL)
33.6 MHz (SECAM)
33.75 MHz (SECAM)
34.42 MHz (NTSC)
TC-21FG10P
GP31 Chassis
Video / Terminals :
RAV In
Monitor Out
High Voltage :
Picture Tube :
Audio Output :
Dimensions :
Mass :
Specifications are subject to change without notice.
Mass and dimensions shown are approximate.
© 2005 Matsushita Electric Industrial Co., Ltd. All
rights
reserved.
distribution is a violation of law.
ORDER NO. MTV0501395C3
Colour Television
AV1, 2
Video In 1 Vp-p 75Ω
Audio In Approx. 400mVrms
Video Out 1 Vp-p 75Ω
Audio Out Approx. 400mVrms
27.5kV±1.5
at zero beam current
A51LXR195X
51cm (21 inches)
Measured diagonally,
90° deflection
16.0W
Height : 473 mm
Width : 648 mm
Depth : 488 mm
24 kg (Net Wt.)
Unauthorized
copying
and

Advertisement

Table of Contents
loading

Related Manuals for Panasonic TC-21FG10P

Summary of Contents for Panasonic TC-21FG10P

  • Page 1 All manuals and user guides at all-guides.com ORDER NO. MTV0501395C3 Colour Television TC-21FG10P GP31 Chassis Specifications Power Source : AC AUTO 110-240V, 50/60 Hz Video / Terminals : AV1, 2 Power Consumption : RAV In Video In 1 Vp-p 75Ω...

  • Page 2: Table Of Contents

    All manuals and user guides at all-guides.com CONTENTS Page Page 1 Safety Precautions 2.5. Adjustment Procedure 1.1. General Guide Lines 2.6. PAL Colour 1.2. Leakage Current Cold Check 2.7. Adjustment 1.3. Leakage Current Hot Check (Fig. 1) 3 Conductor Views 1.4.

  • Page 3: Safety Precautions

    All manuals and user guides at all-guides.com 1 Safety Precautions 1.1. General Guide Lines 1. It is advisable to insert an isolation transformer in the AC supply before servicing this hot chassis. 2. When servicing, observe the original lead dress, especially the lead dress in the high voltage circuits. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit.

  • Page 4: Gp31 Chassis Block Diagram

    All manuals and user guides at all-guides.com 1.5. GP31 Chassis Block Diagram...

  • Page 5: Service Hints

    All manuals and user guides at all-guides.com 2 Service Hints 2.1. Service Position for E-Board 1. Remove the back cover. 2. Stand the TV set as shown in Fig. 2. 3. Remove the A-Board from the TV set by pulling the main board out as shown in Figure 2. Fig.

  • Page 6: Adjustment For White Balance

    All manuals and user guides at all-guides.com 2.3. Adjustment for White Balance Preparation: 1. Receive the white balance pattern and aging should have been performed over 30 minutes. 2. Set the picture menu to DYNAMIC NORMAL. 3. Degausse the CRT face. 4.

  • Page 7: Adjustment Procedure

    All manuals and user guides at all-guides.com 2.5. Adjustment Procedure 2.5.1. +B Voltage 2.5.3. High Voltage Item / preparation Item / preparation 1. Operate the TV set. 1. Receive the crosshatch pattern. 2. Set control as follows : 2. Set to 0 Beam. Brightness ...

  • Page 8: Pal Colour

    All manuals and user guides at all-guides.com 2.6. PAL Colour 1. Receive the PAL B/G studio colour bar pattern and adjust local frequency at the best tuned position. 2. Pic Menu: Dynamic Normal, Confirm Contrast - 100 DAC, Sub Contrast - 21 dac. 3.
  • Page 9 All manuals and user guides at all-guides.com Before Colour Purity, Convergence and White Balance adjustment are attempted, V. Height, H. Centre and Focus adjustments must be completed. Colour Purity Convergence 1. Set the Brightness and Contrast controls to their maximum 1.
  • Page 10 All manuals and user guides at all-guides.com Adjustment of CRT VRS 1. Preparation a. Set DY to CRT not to tilt up and down left and right deflection. b. Set CY to CRT and set CY magnet primarily (Fig. 1) Purity magnet : Set purity magnet that 2 magnets are (TOP POSITION) VRS magnet : Set purity magnet 2 magnets are (HORIZONTAL POSITION) 2.
  • Page 11 All manuals and user guides at all-guides.com Fig. 10 Fig. 11 Notes: 1. Wedge A, B and C should be inserted following the sequence of 1, 2 and 3 shown in Fig. 11. 2. The wedges should be set 120° apart from each other. 3.

  • Page 12: Conductor Views

    All manuals and user guides at all-guides.com 3 Conductor Views...

  • Page 13: Schematic Diagram

    All manuals and user guides at all-guides.com 4 Schematic Diagram...
  • Page 14 All manuals and user guides at all-guides.com...

  • Page 15: A Board

    All manuals and user guides at all-guides.com 4.1. A Board 4.1.1. A Board (1/5) <1A> <2A> <3A> <4A> <5A> <6A> <7A> <8A>...
  • Page 16 All manuals and user guides at all-guides.com 4.1.2. A Board (2/5) <1A> <1B> <2B> <2A> <3B> <3A> <4A> <4B> <5A> <5B> <6A> <6B> <7B> <7A> <8A> <8B>...
  • Page 17 All manuals and user guides at all-guides.com 4.1.3. A Board (3/5) <1B> <1C> <2B> <2C> <3C> <3B> <4C> <5C> <4B> <5B> <6C> <6B> <7B> <7C> <8B> <8C>...
  • Page 18 All manuals and user guides at all-guides.com 4.1.4. A Board (4/5) <1C> <1D> <2D> <2C> <3C> <3D> <4D> <4C> <5C> <5D> <6C> <6D> <7D> <7C> <8C>...
  • Page 19 All manuals and user guides at all-guides.com 4.1.5. A Board (5/5) <1D> <2D> <3D> <4D> <5D> <6D> <7D>...

  • Page 20: L Board

    All manuals and user guides at all-guides.com 4.2. L Board 4.2.1. L Board (1/3) <1A> <2A> <3A> <4A> <5A> <6A>...
  • Page 21 All manuals and user guides at all-guides.com 4.2.2. L Board (2/3) <1A> <1B> <2A> <3A> <2B> <4A> <5A> <3B> <4B> <5B> <6A> <6B>...
  • Page 22 All manuals and user guides at all-guides.com 4.2.3. L Board (3/3) <1B> <2B> <3B> <4B> <5B> <6B>...

  • Page 23: Parts Locations

    All manuals and user guides at all-guides.com 5 Parts Locations...

  • Page 24: Replacement Parts List

    All manuals and user guides at all-guides.com 6 Replacement Parts List...

  • Page 25: Replacement Parts List

    C 1000PF, K, 2KV K2JZ2B000021 ANTENNA PLUG C371 ECEA1CN100U E 10UF, 16V TBM4G1238 MODEL NAME PLATE C373 ECA2EM100B E 10UF, 250V TBM4G3013 PANASONIC BADGE C377 ECA1CM221B E 220UF, 16V TBX4G90411 POWER BUTTON C402 ECA1VM101B E 100UF, 35V TES4G206 COIL SPRING C404 ECQB1333JF P 0.033UF, J,100V...
  • Page 26 All manuals and user guides at all-guides.com Ref. Part No. Part Name & Description Remarks Ref. Part No. Part Name & Description Remarks C689 ECJ2VF1H104Z C 0.1UF, Z, 50V D552 B0HAJP000015 DIODE C801 ECQU2A224BN9 P 0.22UF, 250V D555 B0ACQJ000001 DIODE C802 ECQU2A224BN9 P 0.22UF, 250V...
  • Page 27 All manuals and user guides at all-guides.com Ref. Part No. Part Name & Description Remarks Ref. Part No. Part Name & Description Remarks Q2381 B1ADDF000005 TRANSISTOR R2120 D0GD103JA017 D0GD103JA017 Q3030 B1ABCE000015 TRANSISTOR R2121 D0GD683JA017 F 68KOHM,J, 1/10W Q3031 B1ABCE000015 TRANSISTOR R2122 D0GD683JA017 F 68KOHM,J, 1/10W...
  • Page 28 All manuals and user guides at all-guides.com Ref. Part No. Part Name & Description Remarks Ref. Part No. Part Name & Description Remarks R560 ERG1SJ102E M 1KOHM,J, 1W JA10 ERJ6GEY0R00 M 0OHM,J,1/10W R563 ERJ6GEY0R00 M 0OHM,J,1/10W JA11 ERJ6GEY0R00 M 0OHM,J,1/10W R564 ERDS2TJ393 C 39KOHM,J, 1/4W...

Table of Contents