Installation Of Decoration Panel (2 Way) - LG MFL68686515 Installation Manual

Installation of Decoration Panel (2 Way)

The decoration panel has its
installation direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body.
(Tighten by amount 10 mm in length.) The fixing screws (hexagon M5 screw) are
included the indoor unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
the panel so that the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Decorative panel
Louver motor
Decorative panel fixing screws
(hexagon M5 screws)
Temporary fitting at 2 poles
(Tightening about 10 mm)
!
CAUTION
Install certainly the
decoration panel.
Cool air leakage causes
sweating.
⇨ Water drops fall.
) on the screws fixed in step above, and slide
Inlet Grille
Good example
Air conditioner
unit
Decoration panel
Fit the insulator (this part) and
be careful for cool air leakage
Before installing the decoration panel,
always remove the paper template.
Piping side
Decorative panel
fixing screws
(Hexagon M4 screw)
Bad example
Cool air leakage
(no good)
Ceiling
board
Installation
Control box cover
Display
Lead wire for louver motor
and display
Air conditioner
unit
Ceiling
board
Decoration panel
Installation Manual 21