Cleaning And Maintenance; Cleaning And Care - Brandt BFC584YNW Instruction Manual

4. CLEANING AND MAINTENANCE

Cleaning and care

For hygienic reasons,
(including exterior
accessories) should be cleaned regularly
at least every two months.
Caution! The appliance must not be
connected to the mains during cleaning.
Danger of electrical
cleaning switch the appliance off and
remove the plug from the mains socket.
Exterior cleaning
Clean your appliance
maintain its good appearance.
Wipe the digital panel and display panel
-
with a clean, soft cloth.
Spray water onto the cleaning cloth
-
instead of spraying directly on the
surface of the appliance. This helps
ensure an even distribution of moisture
to the surface.
Clean the doors, handles and cabinet
-
sur- faces with a mild detergent and
then wiped dry with a soft cloth.
Caution!
Don't use sharp objects as they are
-
likely to scratch the surface.
Don't use Thinner, Car detergent,
-
Clorox, ethereal oil, abrasive cleansers
or organic solvent such as Benzene for
cleaning. They may
surface of the appliance and may cause
fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low.
Wipe the inside of the fridge freezer with
a weak solution of sodium bicarbonate,
and then rinse with warm water using a
wrung-out sponge or
completely dry before replacing the
shelves and baskets.
Thoroughly dry all
removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior walls if
the freezer door is opened frequently or
kept open too long. If the frost is too
thick, choose a time when of food stocks
are low and proceed as follows:
the appliance Remove
1.
and interior accessories
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
thawing process.
When defrosting is completed, clean
2.
shock! Before your freezer as described above.
Caution! Don't use sharp objects to
remove
compartment. Only after the interior is
completely dry should the appliance be
regularly to
switched back on and plugged back into
the mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash the seal with
a mild detergent and warm water.
Rinse and dry it thoroughly after
cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
damage the
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged, contact the customer helpline
for assistance. To replace the LED light,
the below steps can be followed:
Unplug your appliance.
1.
Remove light cover by pushing up
2.
and out.
Hold the LED cover with one hand
3.
and pull it with the other hand while
pressing the connector latch.
cloth. Wipe
Replace LED light and snap it
4.
correctly in place.
surfaces and
19
existing food
baskets, unplug
frost from the freezer
and
the