Table of Contents
Advertisement
Open door button
A
ON-OFF and washing pro-
B
gramme selection knob
Time remaining shown on
C
display LED
Spin speed shown on dis-
D
play LED
Heating phase LED
E
Display
F
G
Select spin speed button or
stop with tub full
Press the button to open the door. Chapter 5 – Washing in-
structions – explains how the door works and how to use it.
This knob lets you:
switch the machine on and off by moving it in either
•
direction from the OFF position (knob indicator verti-
cal)
select washing temperatures within the various fab-
•
ric sectors by turning it in both directions
The knob does not move while the programme is running.
The programme is electronically controlled by the machine.
This LED indicates that the display is showing the total dura-
tion of the selected programme before the programme starts,
and the time remaining while the programme is running.
This LED indicates that the display is showing the maximum
spin speed for the selected programme. It stays on while spin
speed is being selected with the relative button.
During the heating cycle, this LED indicates that the pro-
gramme is in the washing water heating phase.
The display shows the following information:
7.
time remaining for the selected programme, given
in hours/minutes.The stated value is an estimate based on the
machine's normal operating parameters (size of load, incoming
water temperature, etc.). The program time may therefore be a
few minutes longer or shorter than stated here.
8.
delayed start (for models featuring this option).
Given in hours/minutes. When the time remaining before the
programme starts is less than 60 minutes, this information is
given in minutes/seconds.
9.
spin speed
10.
cycle pause - flashing STOP
11.
end of cycle - END
12.
error codes
To find out which of the first 3 pieces of information are
shown on the display, check which of the LED's, C, D, or N (the
latter for models featuring the delayed start option) is lit.
Press the button repeatedly to select the required spin
speed. The following spin speeds are available:
0000: spin disabled and stop with tub full. The ma-
•
chine does not perform the final spin and ends the
washing programme with water in the tub. To drain
the water, see the explanations shown in paragraph
5.14
from 600 rpm to the maximum speed indicated for
•
the model: for cotton and coloured programmes,
speed increases by 100 rpm starting from 600 rpm
up to the maximum speed indicated for the model
from 600 to 900 rpm: for synthetics, delicates and
•
woollens programmes, speed increases by 100 rpm
starting from 600 rpm up to 900 rpm.
32
Advertisement
Table of Contents
