Advertisement
CHARGING
1.
Before initial use, charge for four hours to fully charge.
2.
When charging, connect the DC end of the supplied adapter to the battery
charging port and plug the adaptor into a 100~ 240V power outlet.
3.
The LED light on the device flashes regularly, showing the battery level and
indicating that it is charging.
4.
The first indicator shows that the remaining battery is 20% -35%; the second
indicator shows that the remaining battery is 40% -60%; the third indicator shows
that the remaining battery is 65% -80%; the fourth indicator will illuminate when
the remaining power is 85% -100%.
5.
The battery can be charged at any time and any power level. The device cannot be
turned on when charging.
6.
When battery is exhausted to less than 5% and the first LED flashes, the device will
need to be charged before being used again
7.
The average running time of the product when it is fully charged is about 3 hours.
This may be affected by the gear level used and the pressure applied.
OPERATION
1.
Press and hold the power button to enter the first gear. Each time you press the
button, the gear will increase by one stage until it reaches the third gear. In the 3rd
gear, press the button to enter the standby mode. After restarting, press the button
to enter the 1st gear after 3 seconds.
2.
In any gear, press and hold the power button for 2 seconds to turn the unit on/off.
3.
Intelligent protection: After 10 minutes of continuous use, the device will need to be
restarted before it can be used again.
Advertisement
