Table of Contents
Advertisement
MOUNT HYDRAULIC CYLINDER(S)
cont.
Note: Ensure Hydraulic Cylinder(s) are tightly fastened as
described in previous step before continuing.
1.
Align the upper Hydraulic Cylinder mounting hole with the
corresponding holes on the H-Frame as shown in Figure 12
& 13.
Note: The H-Frame may need to be lifted and rotated upward to
allow proper alignment.
2.
Insert one (1) 3/4" Cylinder Pin into the cylinder mounting
plate through the Hydraulic Cylinder upper mounting hole
as shown in Figure 13.
3.
From the inside of the mounting plate, insert one (1) 3/8" Hex
Bolt through the mounting plate and the hole on the Cylinder
Pin shown in Figure 13.
4.
Attach one (1) 3/8" Lock Washer and one (1) 3/8" Hex Nut to
the protruding end of the Hex Bolt and fasten with
appropriate wrench until secure as shown in Figure 13.
5.
Repeat these steps for the remaining three (3) Hydraulic
Cylinders.
Figure 12
PARTS REQUIRED TO MOUNT HYDRAULIC
3/8" x 4-1/2" Hex Bolt (4)
3/4" Cylinder Pin (4)
13
CYLINDER(S)
Hydraulic Cylinder (4)
3/8" Lock Washer (4)
3/8" Hex Nut (4)
Figure 13
Advertisement
Table of Contents
