Mount Bow Side H-Frame - Golden Tornado 4-CYLINDER Installation Manual

MOUNT BOW SIDE H-FRAME

Note: For this step, ensure the Bow Side H-Frame is being used.
Note: Hinge Bushings are preinstalled on Side Beam.
1. Align the mounting holes on the Bow Side H-Frame hinge
plate with the Hinge Bushings located on the Side Beam as
shown in Figure 10.
2. Insert one (1) 1/8" Cotter Pin into one (1) 3/4" x 5" Hinge Pin,
bending the tines of the Cotter Pin outward and apart,
securing the Cotter Pin within the Hinge Pin.
3. Attach a Lollipop Washer to the open end of the Hinge Pin.
4. Slide the Hinge Pin through the hinge plate as shown in
Figure 10.
5. Insert one (1) Lollipop Washer and one (1) 1/8" Cotter Pin into
the protruding end of the Hinge Pin, bending the tines of the
Cotter Pin outward and apart, securing the Cotter Pin within
the Hinge Pin.
6. Repeat this step for the opposite side of the Bow Side H-
Frame.
Figure 9
PARTS REQUIRED TO MOUNT BOW SIDE H-
Lollipop Washer
(4)
3/4" x 5" Hinge Pin (2)
11
FRAME
Bow Side H-Frame
1/8" Cotter Pin (4)
Figure 10