Simplicity S65S Owner's Manual page 8

ASSEMBLING THE VACUUM
WARNING: The S65 battery included
can only be used with the S65 model
as intended.
Installing the Battery
Push the battery into the battery
compartment until it clicks into place
(Fig. 1). Push the second battery into
the charging dock on the base of the
Storage Charging Station until it clicks.
(Fig. 2a)
Removing the Battery
Press the two battery release buttons
and pull the battery pack out of the
vacuum (Fig. 1) or the charging dock
(Fig. 2a).
Charging the Battery
(S65P)
The battery is partially charged and will
run for a short time.
1. Set the vacuum onto the Storage/
Charging Station, ensuring the
connection between points on vacuum
with Storage/Charging Station
(Fig. 2b).
2. Plug the battery charger into the
Storage/Charging Station and into
an electrical outlet (Fig. 2c). The
indicator light on the battery will
be red while the battery is charging.
When the indicator light is blue,
the battery is fully charged (Fig. 3).
Charging time is approximately
4-5 hours.
3. The second battery will charge
whether the vacuum is on the Storage/
Charging Station or not. The charging
dock indicator light is on top of the
Storage Charging Station arm (Fig. 2d)
6
(S65P)
Fig. 1
Fig. 2b
Fig. 2
Fig. 3
Battery Indicator Light
Solid Blue = Fully Charged
Solid Red = Low Battery
Fig. 2d
Fig. 2c
Fig. 2a