Indoor Unit; Remote Controller; Outdoor Unit; Preparation Before Operation - Mitsubishi Electric MSY-GN09VF Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART

Indoor unit

Front panel
Air fi lter
(Nano platinum
fi lter)
Air cleaning fi lter
(Electrostatic anti-allergy
enzyme fi lter)
Horizontal vane
Air outlet
Remote control receiving section
Operation indicator lamp
Emergency operation switch

Outdoor unit

Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller could
malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low. In about
7 days after the indicator starts lights up, the remote controller stops working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with expired
shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate correctly.
En-3
Heat exchanger
Air inlet
Emergency
operation
switch
Page 4
Page 4
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.

Remote controller

Operation display
section
OFF/ON
(stop/operate)
button
FAN speed
control button
Page 5
Operation
select button
Page 4
ECONO
COOL
button
Page 6
VANE
control button
Page 5
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Setting current time
1.
Press CLOCK.
3.
Press CLOCK again.
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
Battery replacement
indicator
Page 3
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
i-save button
Page 5
TIME set buttons
Page 3, 6
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote controller
holder in a place where the
signal can be received by
the indoor unit.
2.
Press the TIME buttons to set
the time.
Each press increases/de-
creases the time by 1 minute
(10 minutes when pressed
longer).