Chapter 6. Configuring Dte Options; Dte Options; Dte Rate; Figure 6-1. Dte Rates For 56 Or 64 Kbps Loop Rate - ADTRAN DSU III ARdc Manual

Chapter 6

DTE OPTIONS

The DTE OPTIONS menu is used to select the configuration parameters
that control the operation of the DSU III ARdc's DTE interface.

DTE Rate

The selectable DTE rates over a 56 or 64 kbps loop are shown in Figure 6-
1 . If a slower loop rate is selected, then the DTE rate will either match the
loop rate or it can be set to 1.2K (see Figure 6-2 on page 6-3). The factory
default setting is S
1=LOCAL
3=CONFIG
2=REMOTE ENTER ADDRESS
The equivalent AT commands for setting the DTE rate for a 56 kbps loop
rate are shown in Table 6-1 on page 6-2.
61200270L1-20
Configuring DTE Options
A L
AME S OOP
1=NETWORK OPT.
2=DTE OPTIONS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND

Figure 6-1. DTE Rates for 56 or 64 kbps Loop Rate

DSU III ARdc User Manual
.
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTION
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A=SR OPTIONS
1=2.4K
2=4.8K
3=9.6K
4=19.2K
5=38.4K
6=56K/57.6K FOR 64kpbs Loop
7=SAME AS LOOP 1=SCRAMBER OFF
8=1.2K 2=SCRAMBLER ON
3=SUPPRESS LBE
6-1