What To Do If The Descaling Procedure Is Interrupted - Philips EP4010 User Manual

English
18
2
1
CALC
CLEAN
5 Pour the descaling solution into the water tank. Fill the water tank with
fresh water up to the CALC CLEAN level indication. Place the water tank
back into the machine. Press the OK button to confirm.
-
The first phase of the descaling procedure starts. The machine starts
dispensing the descaling solution at intervals.
-
The display shows the descaling icon, the phase indication and the
duration. This first phase takes 20 minutes.
6 Let the machine dispense the descaling solution until the water tank is
empty.
7 Remove the water tank and rinse it.
8 Fill the water tank with fresh water up to the CALC CLEAN level
indication. Place the water tank back into the machine.
9 Remove and empty the container and place it back under the coffee
dispensing spout. Press OK to confirm.
10 The second phase of the descaling procedure starts, which is the rinsing
cycle. This phase takes 3 minutes. The display shows the rinsing icon and
the duration of the phase.
Note: If the water tank is not filled up to the CALC CLEAN level, the
machine may require another rinsing cycle.
11 Wait until the machine stops dispensing water. The descaling procedure
is finished when the tick appears on the display.
12 Press the OK button to exit the descaling cycle. The machine starts
heating up and performs the automatic rinsing cycle.
13 Remove and empty the container.
14 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
15 Install a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!
16 Reinsert the classic milk frother.

What to do if the descaling procedure is interrupted

If the machine gets stuck during descaling, you can exit the descaling
procedure by pressing the standby button. If this occurs, or in case of a
power failure or accidental disconnection of the cord, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication
and switch the machine back on. The machine will heat up and perform
an automatic rinsing cycle.
3 Before brewing any beverages, perform a manual rinsing cycle. To
perform a manual rinsing cycle, first dispense half a water tank of hot
water (see 'Hot water ') and then brew 2 cups of pre-ground coffee
without adding ground coffee (see 'Brewing coffee with pre-ground
coffee').
Note: If the descaling procedure was not completed, the machine will
require another descaling procedure as soon as possible.