English
12
Hot water
Adjusting volume and taste
Adjusting coffee volume
Adjusting coffee strength
1
2
3
4
5
Warning: Danger of scalding! Dispensing may be preceded by
small jets of hot water. Use the appropriate protective handle
only.
1 Place a jug under the classic milk frother.
2 Press the STEAM/WATER button.
-
The display shows HOT WATER.
3 Press the OK button to confirm.
-
The machine starts dispensing water.
4 To stop dispensing hot water, press the OK button.
You can adjust the volume of the beverage brewed according to your taste
and to the size of the cups.
1 To adjust the espresso volume, press and hold the ESPRESSO button
until the display shows the MEMO icon.
-
The machine enters the programming phase and starts to brew the
selected beverage.
2 Press the OK button when the cup contains the desired amount of
espresso.
-
The tick on the display shows that the button is programmed: every
time it is pressed, the machine brews the set espresso volume.
Note: To set the volume of espresso lungo and classic coffee, follow the
same procedure: press and hold the button of the beverage until the MEMO
icons appears on the display and press the OK button when the cup
contains the desired amount.
To change the coffee strength, press the AROMA STRENGTH button. Each
time you press the AROMA STRENGTH button, the aroma strength changes
by one degree. The display shows the chosen strength, which is only saved
if you brew a coffee.
1
Very mild
2 Mild
3 Regular
4 Strong
5 Very strong
Note: After adjusting the coffee strength, the display shows the main menu
again and saves the chosen aroma strength when you brew a coffee.