Flush-fitting
KY-R644CL can be fitted flush when installing.
Installing KY-R644CL
Only suitable for installation on heat and water resistant worktops such as
■
marble, natural stone, solid wood (if cut out edges are sealed).
Mount onto other types of worktops only with the recommendation of the worktop
■
manufacturer.
Remove the cushion from the underside of the appliance before flush fitting.
■
The internal width of the base unit must be at least as wide as the internal cut-out
■
width for the hob. This is to ensure that the casing can be easily removed for
maintenance.
Before sealing in, test that the appliance works. Grout the perimeter using a
■
heat resistant silicone. Smooth the seal with a suitable finishing product. Follow
the silicone instructions and do not turn on the appliance until the silicone is
completely dry.
50
Caution
Please observe the diagrams for the cut-out dimensions in granite
■
and marble worktops.
Using unsuitable silicone may cause permanent colour changes
■
to marble worktops.
Uninstalling the Hob KY-R644CL
Disconnect the appliance from the mains.
■
Remove the silicone seal from the perimeter with a suitable tool.
■
Push the appliance upwards from below to remove it.
■
Caution
Do not try to remove the appliance by prying it out from above.
■
R3
560
490
29
(measurement: mm)
R3
5.5
594
17
45