Table of Contents
Advertisement
2.10 EtherCAT
2.11 USB interface
2.12 LED indicators
LED
+24V
Power indicator for 24V
RUN
System running indicator. Twinkle once every 1second.
Under test mode, twinkle once every 3 seconds.
OUT0
Shutter signal indicator
OUT1
Alarm signal indicator
OUT2
Signal Indicator for OUT2
OUT3
Signal Indicator for OUT3
OUT4
Signal Indicator for OUT4
IN0
Shutter signal indicator of the input from motion controller
IN1
Laser control signal indicator of the input from motion controller
IN2
Laser piercing signal indicator of the input from motion controller
IN3
Alarm signal indicator of the input from motion controller
IN4
Indicator for IN4
USB
USB indicator when upgrading the firmware.
SHENZHEN RUIDA TECHNOLOGY
EtherCAT® is a registered trademark and patented technology, licensed by
Beckhoff Automation GmbH, Germany. If RDEncLas400G do not support
EtherCAT. Only RDEncLas400N support the EtherCAT.
USB interface is specialized for U disk. This interface is usually for
firmware upgrading. Never connect this to the USB interface on the
computer.
RDEncLas400G intelligent laser control module
Description
15
Advertisement
Table of Contents
