Advertisement
AMR/AMI Terminal Block Hookup
The following table provides for compatible endpoint connections to the output module.
Terminal
Function
4
Utility AMI Clock
5
Utility AMI Data
6
Utility AMI
Ground
*Alternative color coding: Manufacturers occasionally substitute a WHITE wire for a GREEN wire.
IMPORTANT: Utility AMI/AMR Terminal Block Hookup (Terminals 4-5-6): Apply color-coding that
pertains to the manufacturer of the AMI/AMR endpoint (or manufacturer of the specialty cable, such
as Nicor or Itron).
Signal Terminal Block Hookup
The following table provides connections for respective signal options to destination system.
Terminal
7*
8*
9
10
11
12
*Important: The Signalizer output module provides loop power, therefore, there is no need to add an
additional loop excitation power supply.
LED Indicator
After powering the module, the following LED indications may be observed:
The Upper Yellow 'Heartbeat' LED should light up YELLOW with an
•
OCCASIONAL BLINK, signifying that the Signalizer is working.
The Upper Green 'Meter OK' LED should light up SOLID GREEN, signifying
•
that the meter has been successfully detected; if the meter is not detected,
then the 'Meter OK' LED will emit a fast (10Hz) blink.
•
The Lower Yellow LED will follow the Pulse Output (LED ON = Contact
Closure).
•
The Lower Green LED will light up SOLID GREEN during periods when
Positive Flow is Detected.
Neptune
Neptune
Endpoint
(or other)
w/Std
Endpoint
Cable
w/Nicor
Cable
Black
Red
Red
Green|White
Green
Black
Table 2
Function
Notes
4-20mA +
Settable Range via DIP
Switches
4-20mA -
Pulse +
Solid State Dry Contact (N-O)
500mA Max, 60v Max
Pulse -
Alarm +
Solid State Dry Contact (N-O)
500mA Max, 60v Max
Alarm -
Table 3
Neptune
Sensus, Badger,
(or other)
Mueller, Zenner,
MIU w/Itron
Master-Meter,
Cable
Metron-Farnier, RG3,
Kamstrup Endpoints
Black
Red
Red
Green|White
White|Shield
Black
Elster AMCO
Endpoint
White|Green
Red
Black
Upper
LEDs
Lower
LEDs
Figure 4
4
Advertisement
