Advertisement
4
Figure 7
1. Current rate
2. Preset-rate icons
6. Select the job-menu icon in the upper right of the
screen.
7. Enter a new name for the job or leave the default time
stamp
(Figure
8).
Figure 8
1. Job-menu icon
8. Open the job-menu icon.
9. Select the work region you are going to spray (i.e.
fairways, greens, tees, etc.)
g031494
3
2
3. Decrease and increase
icons
4. Sprayer-controller icon
3
2. Enter a new name or use
the default time stamp
(Figure
9).
3
1
1. Job-menu icon
2. Configure-job regions icon
10. Select the excluded regions that are not to be sprayed
(bunkers, trees, hazards, etc.)
Note: Refer to the standard mode videos for spraying
a boundary inside another boundary.
11. Turn the section switches (located between the seats)
to the
ON
1
2
g031484
1. Boom switch, left boom
2. Boom switch, center boom
12. To start spraying, turn on the master-switch icon (the
master-switch turns green) and drive into the spray
area
(Figure
Note: The machine starts spraying when the sprayer
crosses into the correct spray area.
Note: The display shows areas to be sprayed with
light gray and non-spray areas with a dark gray. If the
display shows all light gray, every area can be sprayed.
Note: The display, receiver, and section controller will
power down when the machine key is turned to the
position. A power switch (green) for the display is
OFF
located on the back, left side of the console.
4
Figure 9
3. Select the job region
position
(Figure
10).
1
2
3
g031290
Figure 10
3. Boom switch, right boom
2).
1
2
g031485
Advertisement
