IDS 860-06-0005 Manual

IDS Two Channel Remote Receiver
IDS Two Channel
Receiver (Digital)
P/N 860-06-0005
Specifications
Power Supply 12V - 16V DC
Max. Power Consumption 175mA
Weight 145g
Dimensions (H x W x L) 33 x 66 x 104
Colour White
Channels 2
Users 238
Passives (Supervised) 64
IDS
IDS 700-284-5 AUG 2005 VER 1.40
1
IDS Two Channel Remote Receiver
2. Features
Two channel receiver
•
High noise immunity
•
238 Users + 64 supervised RF devices may be
•
learned
Signal Jamming Detection and Ambient Noise
•
Level indication
Advanced RF anti-collision software
•
Individual relay pulse periods selectable up to 10
•
minutes
Dedicated panic remotes may be learned
•
Selectable retrigger protection on any relay
•
Panel arming / disarming / stay arming and panic
•
through keypad bus
Expansion of panel zones with RF devices such
•
as RF passives.
3. Introduction
The IDS Digital Wireless Receiver is an extremely versatile
receiver unit that may be used either as a standalone
product or in conjunction with any DIGITAL IDS alarm panel
such as the IDS 816, 1224 or 1632. When used with a
DIGITAL IDS alarm panel, the receiver connects onto the
same communication and power bus as the keypad and
no other connections are needed to make use of any of
the advanced receiver functions.
4. Installation and Wiring
The IDS Digital Wireless receiver may be used in
•
either a standalone mode or connected to an IDS
DIGITAL alarm panel.
When used in standalone mode, the receiver
•
needs a supply of between 12V and 16V DC. The
Data lines D+ and D- do not need to be connected.
When connected to a DIGITAL IDS alarm panel,
•
the D+ and D- data lines must be connected to
the panelís D+ and D- data lines. (Connection of
relays to arm and disarm the panel via zones is
NOT needed. Arming and disarming of the panel
is done through the data bus.)
IDS
2
IDS Two Channel Remote Receiver
The Normally Open (NO), Normally Closed (NC)
•
and Common (COM) outputs of both relays are
available to be connected to external devices such
as gate operators or other alarm panels.
Relay 4ís NO contact is only available with jumper
•
6 in position 2. When Jumper 6 is in position 1
Relay 4ís NO contact is connected to ground via
the tamper switch on the receiver.
For ease of programming Jumper 5 may be used
•
to remove power to the unit after installation.
5. Switches, Jumpers, and Relays
The IDS Digital Wireless Receiver has 8 DIP
•
switches, 1 Tamper switch and 2 Jumpers
The 8 DIP switches are used to program the
•
receiver and adjust its available features. When
connected to an IDS DIGITAL alarm panel the
programming of users and RF devices such as
RF Passives are done through the panel keypad.
The programming of any of the other features does
however still need to be done using the DIP
switches.
Jumper 5 is the power jumper that may be used to
•
remove power from the unit when required to do
so during programming.
Jumper 6 selects between Relay 4ís NO contact
•
or the Tamper Switch Contact. The tamper switch
is internally connected to ground.
Any of the relay outputs may be used to switch a
•
maximum of 3A at a maximum of 24V DC. The
relays are not intended for switching high voltage
signals directly such as lights or motors.
IDS
3