Roper Rhodes HAM450B Manual

BEFORE YOU START

It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. This can be done through the back
rail (fixings not included.)

FITTING HANDLES

• A pilot hole located at the back of the door can be drilled if
using a single screw knob.
• If you have chosen a pull handle with 2 screws then please
pilot and then drill through the door with the handles in the
desired location.
• Carefully drill any holes using a clamped block of wood to
protect the front of door - See figure 1.
• The handles can simply be screwed into place using the
screws supplied.
• If you choose third party handles please measure carefully
before drilling.

FITTING CERAMIC BASIN

• Apply a layer of silicone sealant to the basin on all 4 sides to
be fixed to the panels, back rail and front section as per figure 2.
• The basin should be held in place while the silicone cures.
Recommended
position for handle
pilot holes
Figure 1
Customer Services, Roper Rhodes Ltd, Brassmill Lane Trading Estate, Bath, BA1 3JF
Tel:01225 303 900 | Fax: 01225 448 877
Email: sales@roperrhodes.co.uk | Web: www.roperrhodes.co.uk
Recommended
position for self
adhesive nameplate
Recommended
for knob (pilot
hole included)
HAMPTON
CLOAKROOM UNIT / HAM450B
Please retain for future use
Figure 2
RR-HAMCLK REV : JH/08/2016